AEG KVH 32 Betriebsanweisung PDF herunterladen (Seite 17)

11. (Standard Installation) When the antenna unit is

installed with the connectors facing the rear of the

vehicle, the drain holes are located as shown in

Figure 2-5.

Figure 2-5

(Standard Installation) Baseplate Connectors Facing

Rear of Vehicle - Factory-drilled Drain Holes

(Alternate Installation) If the antenna unit is

installed with the connectors facing the front of the

vehicle, you MUST drill out

⁄16" (5 mm)-drain holes

in the rear-facing side of the baseplate (see

Figure 2-6). Then plug the existing factory-drilled

drain holes with silicone sealant (shown in Figure

2-5).

Figure 2-6

(Alternate Installation) Baseplate Connectors Facing

Front of Vehicle - Recommended Drain Holes

2-6

A Guide to TracVision R5/R4

(Alternate Installation Only) You

MUST drill out the drain holes as

indicated to ensure that any

moisture that enters the baseplate

is able to drain. Ensure that factory-

drilled holes are completely sealed.

Factory-drilled

Drain Hole Positions

Front of

Vehicle

Recommended

3/16" (5 mm)

Drain Hole Positions

Drain Hole Angle

(relative to baseplate)

Front of

Vehicle

Angle of Hole, relative to front

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 60 61

Keine Kommentare

AEG KVH 32 Betriebsanweisung Seite 17