AEG KVH 32 Betriebsanweisung PDF herunterladen (Seite 12)

2-1

Installation

54-0157 Rev. J

2 Installation

Your TracVision R5/R4 is designed for simple installation and

setup. Just follow these easy steps:

Table 2-1

Installation Process

Step Refer to Section...

1. Choose the hardware locations 2.1

2. Mount the antenna unit 2.2

3. Connect system components 2.3

4. Activate the receiver 2.4

5. Select active satellite 2.5

6. Set the skew angle (Europe only) 2.6

7. Check out system 2.7

8. Configure for remote dish use 2.8

Tools and Materials Required

• Electric drill

•

⁄16" (5 mm),

⁄32" (4 mm), and

⁄32" (2.5 mm) drill bits

and

⁄4" (19 mm) hole saw and auger bit

•

⁄2" wrench

• #2 Phillips and #0 flat tip screwdrivers

• RG-6 or RG-11 (75 ohms) RF cable (if installing

two RF cables - refer to Section 2.3.5 on page 2-12

for details)

• Silicone sealant, RTV, or Sikaflex

•

⁄16" open end wrench

• Construction adhesive (e.g., Liquid Nails)

• Rivet gun and

⁄16" (5 mm) rivets (or other fastener

suitable for your specific roof construction)

• PC with Windows HyperTerminal or, if you are a

KVH-authorized dealer, download the KVH Flash

Update Wizard

Plan the entire installation before

proceeding! Take into account

component placement, cable

running distances between units,

and accessibility to the equipment

after installation.

The Flash Update Wizard is

available to KVH-authorized dealers

through the KVH Partner Portal.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare

AEG KVH 32 Betriebsanweisung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder AEG KVH 32