AEG LF8E8411A Bedienungsanleitung

USER MANUALEN User ManualWashing MachineLF8E8411A

The washing programme is tailored tothe laundry load and the type of fabricwithout consuming more time, energyand water than necessary.• The steam has

6. CONTROL PANEL6.1 Control panel descriptionOn/OSoft PlusDelay StartStart/PauseProgramCottonsExtra RinseSyntheticsDelicatesWool / SilkSteam PrewashS

Maximum load indicator. The indicator flashes during the laundryload estimation (refer to ProSense load detection paragraph) .Maximum laundry indica

As the Stand-by function automaticallydeactivates the appliance to decreasethe energy consumption in a few cases,you may need to activate the applianc

If it is necessary to reducethe spin speed, select aprogramme with a lowerspin speed as default.7.5 Stains/Prewash Press this button repeatedly to act

The appliance decreases the washingtemperature and extends the washingtime to obtain a good washing efficiencyby saving energy. The display shows thei

Programme Programme descriptionAnti-AllergyWhite cotton items. This programme removes micro-organ-isms thanks to a washing phase with the temperature

Programme temperature, maximum spin speed and maximum loadProgramme Default tempera-tureTemperaturerangeMaximum spin speedSpin speed rangeMaximumloadW

Programme options compatibilityProgrammeCottons Synthetics Delicates Wool/Silk Steam OKOPower Anti-Allergy 20 min. - 3 kg Outdoor Duvet OptionsSpin

8.2 Woolmark Apparel Care -BlueThe wool wash cycle of this machine hasbeen approved by The WoolmarkCompany for the washing of woolgarments labelled as

CONTENTS1. SAFETY INFORMATION...32. CONDITIONS OF USE...

10. BEFORE FIRST USE1. Make sure that all transit bolts havebeen removed from the appliance.2. Make sure that the electrical power isavailable and the

Maximum level for quantity ofliquid additives.Compartment for stain remover.Flap for powder or liquiddetergent.Always follow theinstructions that you

Make sure that the flap does not cause ablockage when you close the drawer.11.5 Setting a programme1. Turn the programme dial to selectthe desired was

After touching the Start/Pause button,the maximum declared load indicatorgoes off, the indicator flashes, theProSense starts the laundry loaddetecti

11.11 Cancelling a runningprogramme1. Press the button On/Off to cancelthe programme and to deactivatethe appliance.2. Press the button On/Off again t

• If you have set , the applianceonly drains the water.The option indicator or goes out,while the indicator flashes and thengoes off.3. When th

12.3 Detergents and othertreatments• Only use detergents and othertreatments specially made forwashing machines:– powder detergents for all types offa

Always follow theinstructions that you find onthe packaging of theproduct.13.3 Maintenance washThe repeated and prolonged use of lowtemperature progra

4. Insert the detergent drawer into theguide rails and close it. Run therinsing programme without anyclothes in the drum.13.7 Cleaning the drain pumpW

5. When the bowl is full of water, closethe drainage duct back and emptythe container.6. Repeat the steps 4 and 5 until thewater stops to flowing out.

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f

13.8 Cleaning the inlet hoseand the valve filterIt is recommended to clean both thefilters of the inlet hose and valveoccasionally to remove any depos

14. TROUBLESHOOTINGWARNING!Refer to Safety chapters.14.1 IntroductionThe appliance does not start or it stopsduring operation.First try to find a solu

Problem Possible solutionThe appliance does notfill with water properly.• Make sure that the water tap is open.• Make sure that the pressure of the wa

Problem Possible solutionThe appliance makes anunusual noise and vi-brates.• Make sure the levelling of the appliance is correct. Refer to'Instal

2. Disconnect the mains plug from themains socket.3. Open the filter flap.4. Keep the emergency unlock triggerpulled downward and, at the sametime, op

16. ACCESSORIES16.1 Available inwww.aeg.com/shop or fromauthorised dealerOnly appropriateaccessories approved byAEG ensure the safetystandards of the

d) ‘ASC’ means AEG authorisedservice centres;e) AEG is the brand controlled byElectrolux Home Products PtyLtd of 163 O’Riordan Street,Mascot NSW 2020,

Electrolux, an authorised repaireror ASC.8. This warranty, the contract to which itrelates and the relationship betweenyou and Electrolux are governed

FOR SPARE PARTSor to find the address of your nearest state spare parts centre in AustraliaPLEASE CALL 13 13 50OR EMAIL [email protected].

ENGLISH 39

• The appliance must be connected to the water mainsusing the new supplied hose sets, or other new hosesets supplied by the Authorised Service Centre.

www.aeg.com/au157004860-A-072017

• Always use a correctly installedshockproof socket.• Make sure that the parameters on therating plate are compatible with theelectrical ratings of th

WARNING!Use the gloves.1. Remove the external film. Ifnecessary, use a cutter.2. Remove the cardboard top and thepolystyrene packaging materials.3. Re

10. Remove the three bolts by using thekey supplied with the appliance.11. Pull out the plastic spacers.12. Put the plastic caps, that you find inthe

20O20O45O45OMake sure that the inlet hoseis not in vertical position.3. If necessary, loose the ring nut to setit in the correct position.4. Connect t

Make sure that the drainhose end is not immersed inthe water. There may be areturn of dirty water into theappliance.3. To a stand pipe with vent-hole