AEG LAV88830-W Bedienungsanleitung PDF herunterladen (Seite 25)

Instructions for use

Change the Spin Speed

The spin speed can still be changed or the rinse hold (display 0) set dur-

ing the washing program. Other settings cannot be changed.

Abort program

0 Turn the program selector to OFF (UIT) to abort the washing program.

The washing program can be interrupted at any time by pressing the

START/PAUSE button and then continued by pressing it again.

The washing cycle is finished/Remove the washing.

END (EINDE) is lit at the program sequence display when a washing

program is finished.

The washing machine switches itself into the stand-by mode if no but-

ton is pressed or the program selector is not turned within approx. 3

minutes after the end of the program. Only END (EINDE) is illuminated.

All other displays on the control panel are switched off in order to save

energy. Pressing any arbitrary button cancels the stand-by mode.

• A crease protection phase of approx. 30 minutes follows at the end of

the program if program EASY IRON (STRIJKVRIJ) had been selected.

The multidisplay also shows the remaining time and the display END

(EINDE) is illuminated. You can open the filling door and take the

washing out at any time during the crease protection phase.

• START/PAUSE (START/PAUZE) flashes if spin speed 0 (rinse hold ) was

selected.

0 1. After a rinse hold it is first of all necessary to pump off the water:

–Either press START/PAUSE (START/PAUZE) button (the washing will be

spun according to the just finished program; with the SPIN SPEED

(CENTRIFUGETOERENTAL) button the spin speed can be changed even

during the spin-drying process), or

– turn program selector to PUMP (POMPEN) and then press button

START/PAUSE (START/PAUZE) (the water is pumped off without a

spin), or

– Turn the program selector to SPIN (CENTRIFUG.) or to SHORT SPIN

(KORT CENTRIFUGEREN) and press START/PAUSE (START/PAUZE) but-

ton (the washing is spin-dried normally or with a short spin).

END (EINDE) is illuminated at the end of this program step.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Keine Kommentare

AEG LAV88830-W Bedienungsanleitung Seite 25