AEG KVH 32 Installationsanleitung PDF herunterladen (Seite 8)

7

Determine the necessary type of RF cable(s) and

connectors you need for any RF cables that are

required in addition to what is supplied in the

antenna kit (see Figure 9 and Figure 10 on

page 8). Then follow the guidelines below to

prepare the cable(s).

Note: LMR-400-75 is a suitable substitute.

Up to 100 ft (30 m) Cable Run

Cable RG-6

(KVH part no. 32-0417-0100)

Connector Thomas & Betts SNS1P6

(KVH part no. 23-0170)

Tools Augat IT1000

(KVH part no. 19-0242)

Strip

Lengths

Up to 200 ft (60 m) Cable Run

Cable RG-11

(KVH part no. 32-0566-0200)

Connector Thomas & Betts SNS11AS

(KVH part no. 23-0213)

Tools Thomas & Betts CST596711,

L3011B (KVH part no. 72-0493)

Strip

Lengths

0.25" (6.35 mm)

0.5" (12.7 mm)

0.064" (1.63 mm) dia.

0.25" (6.35 mm)

0.5" (12.7 mm)

0.064" (1.63 mm) dia.

Figure 9: RF Cable Requirements

• Do not reuse old RF cables from a

previous antenna installation. The RF1

cable between the TV-Hub and the

antenna carries not only satellite signal,

but power and data as well. Therefore, the

integrity and reliability of this cable is

critically important.

• RF cables must be rated for 75not 50

• Use of any cables not specified in Figure 9

will void the warranty.

• Low-quality, poorly terminated, or

improperly installed RF cables are the

most common cause of system problems.

Terminate all RF cables with high-quality

“F” connectors using the proper

stripping/crimping tools, exactly to the

manufacturer’s specifications.

• When determining cable lengths, be sure

to account for an adequate service loop,

approximately 8" (20 cm) at both ends of

each cable.

IMPORTANT!

Prepare the RF Cables

5

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare