AEG KVH 32 Installationsanleitung PDF herunterladen (Seite 37)

Configure the IP AutoSwitch

When performing system setup (see “Set Up the

System” on page 29), follow these additional

steps to configure the IP AutoSwitch.

NOTE: KVH recommends that you run the Setup

Wizard in the web interface whenever you change

your system’s configuration by adding or removing

devices.

a. At the AutoSwitch page of the web interface,

select Add IP AutoSwitch (Figure 61).

b. Enter the serial number and choose a friendly

name for the IP AutoSwitch (for example,

“Salon”).

c. Select Save to save your changes.

Select the Master Receiver

Any receiver connected to an IP AutoSwitch can

become the master receiver for the system. The

master receiver controls satellite selection.

a. To choose the master receiver, select it on the

Home page of the web interface, or press the

Master Select button on the associated

IP AutoSwitch.

b. Verify that the LED in the Master Select

button on the IP AutoSwitch is lit green (see

Figure 62). The LEDs for any other IP

AutoSwitches should be lit orange.

Figure 61: Add IP AutoSwitch Screen

140701234

The TV-Hub has a built-in IP AutoSwitch.

Any receiver connected directly to the TV-

Hub can therefore be selected as a master

receiver through the web interface.

IMPORTANT!

Figure 62: IP AutoSwitch LED Status Indications

LED Color Indication

Orange Registered with the system but

not currently the master

Orange,

flashing

Initializing

Red Error:

• unable to communicate with

the system,

• network is not detected, or

•unable to register

Green Registered with the system

and currently the master

Continued Installing an IP AutoSwitch

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 45 46

Kommentare zu diesen Handbüchern

Keine Kommentare

AEG KVH 32 Installationsanleitung Seite 37

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder AEG KVH 32