AEG KVH 32 Installationsanleitung PDF herunterladen (Seite 43)

Assigning Static IP Addresses to DIRECTV Receivers

Once you have identified a valid static IP address

range for the receivers, follow these steps to

assign a unique static IP address within that

range to each receiver.

NOTE: These steps may vary, depending on the

receiver's model and software version. Refer to the

receiver's owner's manual for details.

a. Press MENU on the receiver's remote control

to access the onscreen menu.

b. At the main menu, highlight Settings &

Help. Then select Settings.

c. Highlight and select Network Setup.

d. Select Advanced Setup.

e. Change the IP address to the new static IP

address. (On a Genie DVR, the IP address is

called the "Server IP") (see Figure 70).

f. WITHOUT an Onboard Network

Enter "255.255.255.0" for the subnet mask,

and enter the TV-Hub's IP address for default

gateway and DNS.

WITH an Onboard Network

Enter the router's subnet mask, and enter the

router's IP address for default gateway and

DNS.

g. Highlight and select Connect Now to save

your changes. Disregard any error messages

about missing Internet connectivity. Note this

receiver's IP address and location onboard for

future reference.

h. Repeat this procedure for each additional

receiver. Be careful not to use the same IP

address twice.

Figure 70: IP Address on a DIRECTV Receiver (Example)

WITHOUT an Onboard Network (No Router)

WITH an Onboard Network (Using a Router)

Continued Using a DIRECTV Coax Network

1 2 ... 38 39 40 41 42 43 44 45 46

Keine Kommentare

AEG KVH 32 Installationsanleitung Seite 43