Aeg HC411520GB Bedienungsanleitung PDF herunterladen (Seite 28)

OPERATION

Ignition of the burner

WARNING!

Be very careful when you use open fire in kitchen environment. Manufacturer decline any

responsibility in case misuse of the flame

Always light the burner before you put cookware.

To light the burner:

1. Turn the control knob counterclockwise to the maximum position (

) and push it

down.

2. Keep the control knob pushed for approximately 5 seconds; this will let thermocouple

to warm up. If not, the gas supply will be interrupted.

3. Adjust the flame after it is regular.

If after some tries the burner does not light, check if the crown and its cap are in correct

positions.

Burner cap

Burner crown

Ignition candle

Thermocouple

WARNING!

Do not keep the control knob pushed for more than 15 seconds.

If the burner does not light after 15 seconds, release the control knob, turn it into off posi-

tion and try to light the burner again after minimum 1 minute.

In the absence of electricity you can ignite the burner without electrical device; in this case

approach the burner with a flame, push the relevant knob down and turn it counter-clock-

wise to maximum gas release position.

If the burner accidentally goes out, turn the control knob to the off position and try to light

the burner again after minimum 1 minute.

The spark generator can start automatically when you switch on the mains, after installa-

tion or a power cut. It is normal.

28 Operation

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Keine Kommentare

Aeg HC411520GB Bedienungsanleitung Seite 28