AEG 60000M-BNAE5EURO Bedienungsanleitung PDF herunterladen (Seite 16)

Installation Instructions

Safety Instructions for the Installer

• A device is to be fitted in the electrical installation that makes it pos-

sible to isolate the appliance from the mains with a contact separa-

tion of at least 3 mm on all poles.

Suitable isolation devices include, e.g. cut-outs, fuses (screw type

fuses are to be removed from the holder), earth leakage trips and

contactors.

• In respect of fire protection, this appliance corresponds to type Y (IEC

335-2-6). Only this type of appliance may be installed with a high

cupboard or wall on one side.

• It is not permitted to fit drawers below the cooking surface.

• Protection against electric shock must be provided by the installation.

• The kitchen unit in which the appliance is fitted must satisfy the

requirements of DIN 68930 in respect of stability.

• Built-in ovens and cooking surfaces are fitted with special connector

systems. They may only be combined with appliances with a matching

system.

• All cut surfaces are to be sealed with a suitable sealant for protection

against moisture.

• On tiled work surfaces, the joints in the area where the hob sits on

the surface must be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action springs

must be bonded in place.

• Ensure that the seal is correctly seated in the frame and that it is sea-

ted against the work surface without leaving any gaps. Additional

silicon sealant must not be applied, this will make removal more diffi-

cult in the event of the need for service.

• To remove the hob, it must be pressed out from below.

Electrical Connection

• Connect the 12-pole compact connector on the cable harness to the

mating connector from the built-in oven or panel.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

Keine Kommentare

AEG 60000M-BNAE5EURO Bedienungsanleitung Seite 16