7.10 Starting a programme
To activate the programme push the
Start/Pause button. The LED above the
push button changes the colour to red.
7.11 Change a programme
To change a programme, turn the pro-
gramme dial to
(off) and then set the
programme again.
7.12 At the end of programme
When the drying cycle is complete, LEDs
End and Filter are on . If the Buzzer func-
tion is on, an acoustic signal sounds in-
termittently for about one minute.
The drying cycles (except for the
Wool care programme) are auto-
matically followed by an anti-
crease phase which continue
around 30 minutes. The laundry
can be removed during the anti-
crease phase (The laundry should
be taken out towards the end of
the anti-crease phase at the lat-
est to prevent creases from form-
ing.) . If Long anti-crease function
is set, the anti-crease phase is in-
creased by 60 minutes.
To remove the laundry:
1.
Turn the programme dial to (off)
2.
Open the appliance door.
3.
Remove the laundry.
4.
Close the appliance door.
After each drying cycle: clean the
filter
(See chapter CARE AND CLEAN-
ING.)
8. HINTS AND TIPS
8.1 Ecological hints
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry
becomes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If necessary
clean the condensate before (e.g. with
a coffee filter) to remove possible
small pieces of fluff.
• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
8.2 Average laundry weights
bathrobe 1200 g
quilt cover 700 g
man’s work shirt 600 g
man’s pyjamas 500 g
sheet 500 g
tablecloth 250 g
man’s shirt 200 g
night dress 200 g
pillow case 200 g
towelling towel 200 g
blouse 100 g
ladies’ briefs 100 g
men’s under-
pants
100 g
napkin 100 g
tea cloth 100 g
ENGLISH 11
Kommentare zu diesen Handbüchern