AEG CKB6540ACM Bedienungsanleitung PDF herunterladen (Seite 28)

WARNING!

Only liquid sealants can be

used when the inlet gas pipe

is fitted i.e.: do not use the

P.T.F.E. sealant tape.

When the installation is

complete, carry out a gas

tightness test and make sure

that the seal of each pipe

fitting does not leak.

Use flexible tubing, which

comply with the BS.669

current edition.

A

B

C

C

D

E

WARNING!

The gas bayonet connector

must be in the marked area.

Dimension mm

A 250

B 680

C 50

D 250

E 580

13.7 Pressure test

The Rapid injector is used as a pressure

test point.

1. Connect the pressure gauge to the

Rapid injector.

2. Examine the supply pressure by

turning the Rapid burner and one

other burner fully on, and lighting

them. The pressure must be 20 mbar

for Natural Gas.

3. Turn the taps off and disconnect the

pressure gauge.

4. Make sure that all burners work

correctly.

13.8 Checking the hob burners

1. Lift the lid.

2. Put on the burner crowns and caps.

Make sure that they are correctly

seated.

3. Put on the pan supports.

4. Light one of the hob burners.

To light the hob burner refer to the

"Ignition of the hob burners".

Check if the flame is regular.

Check each of the burners.

5. Turn the knob for the hob to the off

position.

13.9 Checking the Lid Safety

Device

1. Lift the lid.

2. Light one of the hob burners.

To light the hob burner refer to the

"Ignition of the hob burners".

3. Close the lid. There should be no gas

supply to the hob burners. The

burner goes out.

4. Turn the knob to the off position and

lift the lid. The gas supply should be

restored to the hob burners, when

you turn the knob on.

13.10 Electrical installation

WARNING!

The manufacturer is not

responsible if you do not

follow the safety precautions

from Safety chapters.

This appliance is supplied without a main

plug or a main cable.

www.aeg.com

28

1 2 ... 23 24 25 26 27 28 29 30 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare