AEG HK973506FB KE1 Bedienungsanleitung PDF herunterladen (Seite 17)

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

8.3 Connection cable

• The hob is supplied with the

connection cable.

• Replace the damaged mains cable

only with the spare parts cable. Speak

to your local Authorised Service

Center.

WARNING!

All electrical connections

must be made by a qualified

electrician.

CAUTION!

Do not drill or solder the

wire ends. This is strictly

forbidden!

CAUTION!

Do not connect the cable

without cable end sleeve.

Two-phase connection

1. Remove the cable end sleeve from

black and brown wires.

2. Remove an insulation of the brown

and black cable ends.

3. Apply a new wire end sleeve of 1.5

mm² on each cable end. (special tool

required).

Cable cross section

230V~ 400V 2~N

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N

Green - yellow Green - yellow

N Blue and blue Blue and blue N

L Black and brown Black L1

Brown L2

8.4 Attaching the seal

1. Clean the worktop around the cut

out area.

2. Attach the supplied seal stripe to the

lower edge of the hob along the

outer edge of the glass ceramic. Do

not extend it. Make sure that the

ends of the seal stripe are located in

the middle of one side of the hob.

3. Add some mm when you cut the seal

stripe to the length.

4. Push the two ends of seal stripe

together.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 67 68

Kommentare zu diesen Handbüchern

Keine Kommentare

AEG HK973506FB KE1 Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder AEG HK973506FB KE1