AEG HD955100NB Bedienungsanleitung

HD955100NB EN User Manual

lets the thermocouple warm up. Ifnot, the gas supply is interrupted.3. Adjust the flame after it is regular.If after some tries the burnerdoes not lig

• You do not deactivate a cooking zoneor change the heat setting. Aftersome time comes on and the hobdeactivates. See below.The relation between hea

To activate the function: touch ofthe timer. comes on. When theindicator of the cooking zone starts toflash slowly the time counts up. Thedisplay

• you touch • Minute Minder comes down• Count Down Timer comes down• you put something on the controlpanel.Power management function• Cooking zones ar

CAUTION!Make sure that the bottomsof pots do not stand abovethe control knobs, otherwisethe flame heats the controlknobs up.CAUTION!Make sure that pot

Heat setting Use to: Time(min)Hints1 - 3 Hollandaise sauce, melt: but-ter, chocolate, gelatine.5 - 25 Mix from time to time.1 - 3 Solidify: fluffy ome

supports are aligned with the centreof the burner.6.3 Cleaning the hob• Remove immediately: melted plastic,plastic foil, and food with sugar. If not,t

Problem Possible cause RemedyAn acoustic signal soundsand the hob deactivates.An acoustic signal soundswhen the hob is deactivated.You put something o

Problem Possible cause Remedy and a number come on.There is an error in the hob. Disconnect the hob from theelectrical supply for sometime. Disconnect

conditions of guarantee are in theguarantee booklet.7.3 Labels supplied with theaccessories bagStick the adhesive labels as indicatedbelow:MOD.PROD.NO

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS.

The hob should not be installed in a bedsitting room with a volume of less than20 m³. If it is installed in a room ofvolume less than 5 m³ an air vent

CAUTION!Make sure that the gassupply pressure of theappliance obeys therecommended values.Rigid connection:Carry out connection by using metal rigidpi

of clamps fixed to the side of thecabinet, in order to avoid any contactwith the equipment beneath thecooktop.Electrical RequirementsPermanent electri

phase. There must be no cut or straystrands of wire present. The cordclamp must be correctly attached tothe outer sheath.8.9 Attaching the seal1. Clea

R 5 mmmin.55 mm490 mm830 mm600 mmmin.38 mmmin.2 mmmin.12 mmmin. 2 mmCAUTION!Install the appliance only ona worktop with a flat surface.8.11 Possibilit

safety reasons and to let easy removeoven from the unit.If you install the hobasymmetrically rightward theminimum distance betweenleft edge of the hob

Electric supply: 230 V ~ 50 HzAppliance category: II2H3+ Gas connection: R 1/2" Appliance class: 3 9.5 Gas burners for NATURAL GAS G20 20 mbar

ENGLISH 27

www.aeg.com/shop867305016-A-112014

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible i

• Do not store items on the cooking surfaces.• Metallic objects such as knives, forks, spoons and lidsshould not be placed on the hob surface since th

• Obey the installation instructionsupplied with the appliance.• Keep the minimum distance from theother appliances and units.• Always be careful when

• This appliance is not connected to adevice, which evacuates the productsof combustion. Make sure to connectthe appliance according to currentinstall

2.5 Care and cleaning• Clean regularly the appliance toprevent the deterioration of thesurface material.• Deactivate the appliance and let itcool down

3.3 Control panel layout51 23410 89 76Use the sensor fields to operate the appliance. The displays, indicators and sounds tellwhich functions operate.

Display DescriptionPower function operates. + digitThere is a malfunction. / / OptiHeat Control (3 step Residual heat indicator) : continue cooking