AEG HD955100NB Bedienungsanleitung PDF herunterladen (Seite 22)

of clamps fixed to the side of the

cabinet, in order to avoid any contact

with the equipment beneath the

cooktop.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations.

For your own safety the installation must

be done by a qualified electrician (e.g.

your local Electricity Board, or a

contractor who is on the roll of the

National Inspection Council for Electrical

Installation Contracting [NICEIC]).

The manufacturer refuses

to be held responsible, if

these safety measures are

not abided by.

Supply connections

This hob has to be connected to 230 —

240 V ( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L or 1 - live terminal

• N or 4 - neutral terminal

•

or E or 5 - earth terminal

Before carrying out the connection,

make sure:

1. The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2. The supply system is equipped with

an efficient earth connection in

compliance with the current

standards and regulations

3. The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

You must purchase and install the power

cable. Use only a connection cable of

type H05V2V2-F T90 or its equivalent.

Make sure that the cable section is

applicable to the voltage load and the

working temperature.

The wires in the cord are coloured as

follows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

WARNING!

A cut off plug inserted into a

13 amp socket is a serious

shock hazard. Ensure that

the cut off plug is disposed

of safely.

8.8 Replacement of the

connection cable

The replacement of electric

cable must be carried out

exclusively by the service

force centre or by personnel

with similar competencies, in

accordance with the current

regulations.

Make sure that the cable

section is applicable to the

voltage load and the

working temperature. The

yellow/green earth wire (B)

must be approximately 2 cm

longer than the live and

neutral wire (A).

A B

1. Connect the green and yellow (earth)

wire to the terminal which is marked

with the number 5, or the letter 'E', or

the earth symbol

, or coloured

green and yellow.

2. Connect the blue (neutral) wire to the

terminal which is marked with the

number 4, or the letter 'N', or

coloured blue.

3. Connect the brown (live) wire to the

terminal which is marked with the

number 1, or the letter 'L'. It must

always be connected to the network

www.aeg.com

22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare