AEG AW8550TFGVTC Bedienungsanleitung Seite 11

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 12
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 10
12 12
APPLIANCE MAINTENANCE
Regulation of air adjuster (oven burner)
To loosen the screws 4 in order to approach or remove the regulator
2 of the burner at the injector (fig. G3) . In this way, entrace of the
air increases or descreases, obtaining a correct flame.
Be sure that the flame does not lift or light back or present a yellow
colouration .
Regulation of air adjuster (grill burner)
To loosen the screw A (fig. H1) in order to approach or remove
the burner at the injector . In this way, entrace of the air increases
or descreases, obtaining a correct flame. Be sure that the flame
does not lift or light back or present a yellow colouration .
REGULATION AIR ADJUSTER mod. 185
REGULATION AIR ADJUSTER mod. G5
Fig. L Fig. M
A
A
GB
WARNINGS
Isolate the cooker from the electricity supply before attempting to
replace the oven lamp.
The oven lamp used is of a special type withstanding high
temperatures. To replace it, act as follows: disassemble the
protecting glass (A) and replace the burnt lamp with one of the
same type. Reassemble the protecting glass.
DISASSEMBLE OF WORK-TOP
In case it is necessary to repair or replace the inside components,
act as follows:remove the glass lid from its position slipping off it
upwards.
Remove the grids, remove burners and flame-spreaders (see
fig. 13), unscrew the visible screws “V” placed on the work-top
(see fig. 14). Disassemble the work-top by unscrewing the 4 rear
screws “A” (see fig. 15 ).
- To disassemble the control panel, unscrew the 4 screws (B)
fixing the control panel to the oven face ( fig 16 ).
GREASING OF TAPS
WARNING:This operation must be carried out by skilled staff.
If a tap becomes hard to be turned, grease it using a specific
grease withstanding high temperatures. Act as follows: switch the
appliance off, and close the gas tap open the work-top and
disassemble also the control panel as described on the previous
paragraph. Unscrew the two fixing screws from the burner body
(see picture) and remove the cone.
Fig. 16
B
Fig. 15
To raise the cooking
hob end to push in
ahead
A
A
Fig. 14
V
Fig. 13
E 14
25 W - 230 V~
T300°C
A
15
7
D
V
V
A
A
A
A
FIG.H1
FIG.G3
4
2
REGULATION OF AIR ADJUSTER (grill burner )
To do this,
- To loosen the screw (A ) in order to approach or remove the
regulator at the injector (fig M).
In this way, entrace of the air increases or descreases, obtaining
a correct flame.
Be sure that the flame does not lift or light back or present a
yellow colouration .
REGULATION OF AIR ADJUSTER (oven burner )
To do this,
- To loosen the screw (A ) in order to rotate the metal ring at the
end of the burner (fig L ).
In this way, entrace of the air increases or descreases, obtaining
a correct flame.
Be sure that the flame does not lift or light back or present a
yellow colouration .
B
A
A
H
Seitenansicht 10
1 2 ... 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare