AEG 75552G-M Bedienungsanleitung

AUS ERFAHRUNG GUT75552 GGas HobOperating InstructionsIEPERFEKT IN FORM UND FUNKTIONGB

10Guarantee ConditionsStandard guarantee conditionsWe, AEG, undertake that if within 12 months of the date of the purchase this AEG appliance or any p

11Instruction for the InstallerEngineers technical dataBURNER RAPID SEMI-RAPID AUXILIARY TRIPLE(large) (medium) (small) CROWNPOSITION MAX MIN MAX MIN

12Important safety requirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations(Current Edition) and th

13InstallationImportantThis hob must be installed by a competent person to the relevant Gas Standards.Any gas installation must be carried out by a re

14FO 2038Cut Out SizeThe dimensions of the cut-out are given in the diagram.Building InBuilding over a cupboard or drawerIf the hob is to be installed

15FO 2564ON/OFF SWITCHFLEXOUTLETON/OFF SWITCHFLEXOUTLET1FO 25632Building over a kitchen unit with doorProper arrangements must be taken indesigning th

16Fitting the Hob into the worktopCarry out the building in of the hob as follows:• put the sealssupplied with the hob, on theedges of the cut out: p

17Electrical connectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

18Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a double pole switchbetween the hob and the electricity

19Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Pol

2 Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. Ifyou need assistance, contact our Customer C

20A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on Ω (Ohms) x 1 scale andadjust zero if necessary.— Test leads fro

21Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

22CommissioningWhen the hob has been fully installed it will be necessary to checkthe minimum flame setting. To do this, follow the procedure below.-

23Conversion from Natural Gas to LPGIMPORTANTThe replacement/conversion from natural gas to LPG should only be undertakenby a competent person.It is i

35687-8201 10/04AEG Hausgeräte GmbHPostfach 1036D-90327 Nürnberghttp://www.aeg.hausgeraete.de© Electrolux

3Keep this instruction book for future reference and ensure it is passed on toany new owner.These instructions are only valid for countries whose iden

4ContentsGuide to Use the instructionsThe following symbols will be found in the text to guide you throughout the Instructions:Safety InstructionsSt

5Description of the HobInstallationAny gas installation must be carried out by a registered competent person, and inaccordance with existing rules and

6Burner minimum maximumdiameter diameterTriple-crown (ultra-rapid) 160 mm 260 mmLarge (rapid) 160 mm 240 mmMedium (semi-rapid) 120 mm 220 mmSmall (aux

7Before any maintenance or cleaning can be carried out, you must DISCONNECT the hobfrom the electricity supply.The hob is best cleaned whilst it is st

8Something Not Working?If the hob is not working correctly, please carry out the following checks before contactingyour local AEG Service Force Centre

9Service and Spare PartsCustomer CareWhen you contact the Service Centre, they will need the following information:1. Your name, address and post code