AEG L70260TL1 Bedienungsanleitung PDF herunterladen (Seite 21)

4.

Remove the inlet hose behind the

appliance.

5.

Clean the filter in the valve with a

stiff brush or a towel.

90˚

6.

Install again the inlet hose. Make

sure that the couplings are tight to

prevent leakages.

7.

Open the water tap.

11.7 Emergency drain

Because of a malfunction, the appliance

cannot drain the water.

If this occurs, do steps (1) through (3) of

'To clean the drain filter'.

If necessary, clean the filter.

Put the drainage duct back and close the

drain filter flap.

11.8 Frost precautions

If the appliance is installed in an area

where the temperature can be less than

0 °C, remove the remaining water from

the inlet hose and the drain pump.

1.

Close the water tap and disconnect

the inlet hose.

2.

Put the end of the inlet hose in a

container and let the water flow out

of the hose.

3.

Do the Drain programme and let it

operate until the end of the cycle.

4.

Turn the programme knob to Stop

to disconnect the appliance from the

power supply.

5.

Disconnect the appliance.

WARNING!

Make sure that the temperature

is more than 0 °C before you use

the appliance again.

The manufacturer is not responsi-

ble for damages caused by low

temperatures.

12. TROUBLESHOOTING

The start of the appliance does not oc-

cur or it stops during operation.

First try to find a solution to the problem

(refer to the table). If not, contact the

service centre.

ENGLISH 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare