AEG L16810 Bedienungsanleitung PDF herunterladen (Seite 47)

The inlet hose must not be lengthened. If it is too short and you do not

wish to move the tap, you will have to purchase a new, longer hose spe-

cially designed for this type of use.

The inlet hose is provided with a water stop device, which protects

against damage caused by water leaks in the hose which could develop

due to natural ageing of the hose. This fault is shown by a red sector in

the window “A”. Should this occur, turn the water tap off and refer to

your Service Centre to replace the hose.

Water drainage

The end of the drain hose can be positioned

in three ways:

Hooked over the edge of a sink using the

plastic hose guide supplied with the

machine. In this case, make sure the end

cannot come unhooked when the machine

is emptying.

This could be done by tying it to the tap with a piece of string or

attaching it to the wall.

In a sink drain pipe branch. This branch must be above the trap so that

the bend is at

least 60 cm above

the ground.

Directly into a

drain pipe at a

height of not less

than 60 cm and

not more than

90 cm.

The end of the drain hose must always be ventilated, i.e. the inside

diameter of the drain pipe must be larger than the outside diameter of

the drain hose.

The drain hose must not be kinked. Run it along the floor; only the part

near the drainage point must be raised.

Installation

132995660•GB.qxd 06/02/03 09:45 Pagina 97 (Nero/Process Black pellicola)

1 2 ... 42 43 44 45 46 47 48 49

Keine Kommentare

AEG L16810 Bedienungsanleitung Seite 47