Aeg L 70270 VFL Bedienungsanleitung

L 70270 VFLL 70470 FLEN WASHING MACHINE USER MANUAL

TEMPERATURE BUTTON 10Press button 10 to change the defaulttemperature.- - = cold waterACOUSTIC SIGNALSFUNCTIONYou can hear the acoustic signals when:•

PROGRAMMESProgrammeTemperatureType of loadmax. weight of loadCycledescriptionFunctionsCottons95° - ColdWhite and colouredcotton with normalsoil.max. 7

ProgrammeTemperatureType of loadmax. weight of loadCycledescriptionFunctionsRinseAll fabrics. One rinse with ad-ditive spin phaseSPIN REDUCTIONRINSE H

5) Press EXTRA RINSE button to add rinses. With a low spin speed the appliance performsdelicate rinses and a short spin.6) Set this programme to decre

BEFORE FIRST USE1.To activate the drain system, put 2 li-tre of water in the main wash com-partment of the detergent dispenser.2.Put a small quantity

The detergent compartment for the prewash phase, the soak pro-gramme and for the stain function.Add the detergent for prewash, soak and stain remover

4.To use liquid detergent, turn the flapdown.With the flap in the positionDOWN:– Do not use gelatinous or thickliquid detergents.– Do not put more liq

Before you press button 4 tostart the appliance, you can cancelor change the set of the delaystart.CANCEL THE DELAY START1.Press button 4 . The relate

HINTS AND TIPSTHE LAUNDRY LOAD• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that areon the l

Level TypeWater hardness°dH °T.H. mmol/l Clarke2 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.7 17-254 very hard > 21 > 37 >3.7 &g

CONTENTS4 SAFETY INFORMATION5 TECHNICAL INFORMATION6 PRODUCT DESCRIPTION7 CONTROL PANEL11 PROGRAMMES14 BEFORE FIRST USE14 USING THE APPLIANCE14 LOADIN

CARE AND CLEANINGWARNING!Disconnect the appliance from the mainssupply before you clean it.DESCALINGThe water we use contains limescale. If itbecomes

DETERGENT DISPENSERTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquid ad-ditive compartment.4.Cle

To clean the drain pump:1.Open the drain pump door.2.Put a container below the recess ofthe drain pump to collect the waterthat flows out.3.Press the

218.Clean the filter under the water tapand put it back in the pump into thespecial guides.9.Make sure that you tighten correctlythe filter to prevent

45°20°6.Install again the inlet hose. Make surethat the couplings are tight to pre-vent leakages.7.Open the water tap.EMERGENCY DRAINBecause of a malf

TROUBLESHOOTINGThe start of the appliance does not occuror it stops during operation.First try to find a solution to the problem(refer to the table).

Problem Possible cause Possible solutionThe spin phasedoes not operate.The spin phase is off. Set the spin programme. The filter of the drainpump is

Problem Possible cause Possible solution You did not remove thestubborn stains beforeyou wash the laundry.Use special products to removethe stubborn

INSTALLATIONUNPACKING1.Use the gloves. Remove the externalfilm. If necessary, use a cutter.2.Remove the cardboard top.3.Remove the polystyrene packagi

6.Put one of the polystyrene packagingelements on the floor behind the ap-pliance. Carefully put down the appli-ance with the rear side on it. Makesur

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

12.Put the plastic caps in the holes. Youcan find these caps in the user man-ual bag.– We recommend that you keepthe packaging and the transitbolts fo

CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.THE INLET HOSE20O20O20O45O45O45O• Connect the ho

WATER DRAINAGEThere are different procedures to connectthe drain hose:With the plastic hose guide. • On the edge of a sink.• Make sure that the plasti

• Directly to a built-in drain pipe in theroom wall and tighten it with a clip.You can extend the drain hose tomaximum 400 cm. Contact theservice cent

34www.aeg.com

ENGLISH35

www.aeg.com/shop 132928260-A-502011

SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environmen

Water connection• Do not connect the appliance with oldhoses already used. Only use new ho-ses.• Make sure not to cause damage to thewater hoses.• Do

PRODUCT DESCRIPTION1 2 35674810119121Worktop2Detergent dispenser3Control panel4Door handle5Rating plate6Drain pump7Feet for the appliance level8Water

CONTROL PANEL1 2 3456789101On/Off button2Programme knob 3Display 4Start Pause button5Delay start button6Time save button7Extra rinse button8Stain bu

DISPLAY 3A B C DThe display shows:A • The maximum temperature of the programme.B • The default spin speed of the programme.•'No Spin'1) and

D • The programme timeWhen the programme starts, the time decreases with steps of 1 minute.• The delay startWhen you press the delay start button, the