AEG KSK792220M Bedienungsanleitung PDF herunterladen (Seite 52)

12.4 Steam Cleaning

Remove as much dirt as possible

manually.

Remove the accessories and the shelf

support to clean the side walls.

The steam cleaning functions support

the steam cavity cleaning of the oven.

Before you start a cleaning procedure,

make sure that the oven is cool.

When the steam cleaning function works,

the light is off.

1. Fill the water drawer to the maximum

level.

2. Choose the steam cleaning function

in the menu: Cleaning.

Steam Cleaning - the duration of the

function is around 30 minutes.

a) Turn on the function.

b) When the programme ends a

signal sounds.

c) Press a sensor field to turn off the

signal.

Steam Cleaning Plus - the duration

of the function is around 75 minutes.

a) Spray a suitable detergent

uniformly in the oven cavity on

both enamel and steel parts.

b) Turn on the function.

The first part of the programme

ends after around 50 minutes.

c) Press

.

Follow the message

in the display to

complete the

cleaning.

d) Wipe the cavity of the oven with

a non-abrasive surface care

sponge. You can use warm water

or oven detergents.

e) Press .

The final part of the procedure

starts. The duration of this stage

is around 25 minutes.

3. Wipe the cavity of the oven with a

non-abrasive sponge. You can use

warm water.

4. Remove the remaining water from

the water drawer.

After cleaning keep the oven door open

for approximately 1 hour. Wait until the

oven is dry. To speed up the drying you

can heat up the oven with hot air at

temperature 150 °C for approximately 15

minutes. You can get maximum effects of

the cleaning function if you manually

clean the oven immediately after the

function ends.

12.5 Cleaning Reminder

When reminder is displayed cleaning is

necessary. Use the function Steam

Cleaning Plus.

You can enable / disable the function:

Cleaning Reminder in the menu: Basic

Settings.

12.6 Cleaning the water

drawer

Remove the water drawer from the oven.

1. Remove the lid of the water drawer.

Lift the cover in correspondence with

the protrusion in the rear.

XAM

2. Remove the wave-breaker. Pull it

away from the drawer body until it

snaps out.

3. Wash the water drawer parts with

your hands. Use tap water and soap.

Do not use abrasive sponges. Do not put

water drawer inside a dish washer.

After you clean the water drawer parts,

reassemble the water drawer.

1. Snap in the wave-breaker. Push it

into the drawer body.

2. Assemble the lid. First insert the front

snap and then push it against the

drawer body.

www.aeg.com

52

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare