AEG D 5000 Betriebsanleitung PDF herunterladen (Seite 11)

g

31

3

To correctly learn how to use the

machine, when starting it for the first

time, carefully follow the step-by-step

instructions described in the following

paragraphs.

3.2 Filling with water

Each time before switching on the cof-

fee machine, check that there is water

in the water tank, and refill if neces-

sary. The coffee machine requires water

for the automatic rinsing processes

each time the machine is switched on

or off.

0 Remove the water tank (Fig. 4), rinse it

and fill it with fresh water, without

exceeding the MAX line. When remov-

ing the tank, the milk frother must

always be positioned towards the cen-

tre of the machine, otherwise the tank

cannot be removed.

1

Pour only fresh cold water into the

water tank. Never put in other liquids,

e.g. mineral water or milk.

0 Replace the tank, pushing it all the way

in.

3

To always be sure of obtaining a rich

coffee with a full aroma, you should:

– change the water in the water tank

daily,

– wash the water tank at least once a

week in normal washing-up water

(not in the dishwasher). Then rinse

with fresh water.

3.3 Filling the coffee bean container

0 Open the lid on the coffee bean con-

tainer (Fig. 5).

0 Fill the container with coffee beans.

0 Close the lid.

1

Note! Do not put frozen or caramelised

coffee beans in the bean container. Use

only roasted coffee beans! Make sure

that no foreign objects, such as small

stones, enter the coffee bean con-

tainer. Blocking or damage caused by

foreign objects in the grinder might

be excluded from the guarantee.

3

Coffee has been used to factory-test

the appliance, and it is therefore com-

pletely normal for there to be traces of

coffee in the mill. This appliance is

however guaranteed to be new.

3.4 Switching on for the first time

When you operate the machine for the

first time, the coffee machine has to be

vented.

0 Check that the water tank is full and

that power cable is plugged into the

power outlet.

0 Move the milk frother towards the

outside and place a cup underneath

(Fig. 6). Then turn the machine on by

pressing the button (Fig. 7).

0 Immediately after, within a maximum

of 30 seconds, turn the steam knob

anticlockwise until it stops (Fig. 8) (it is

normal for the machine to make some

noise).

After few seconds, a little water will

come out of the milk frother.

0 When there is around 30 cc in the cup,

turn the steam knob half a turn clock-

wise (Fig. 8) until it stops, so as to stop

the water coming out.

0 Wait for the and lights to stop

flashing and turn on steady. (When the

lights are flashing it means that the

machine is pre-heating, while when

they are on steady it means that the

machine has reached the ideal temper-

ature for making coffee).

A few moments before the lights stop

flashing the machine automatically

performs a rinse cycle: a little hot

water will come out of the delivery

spouts and will be collected in the drip

tray underneath.

3

Tip: for a hotter, short coffee (less than

60 cc), first fill the cup with the hot

rinsing water. Then leave it inside for a

few seconds (before emptying it) so as

to pre-heat the cup.

At this point, the machine is ready for

use.

822_949_352 CS5200.book Seite 31 Mittwoch, 9. Mai 2007 7:26 19

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare