AEG HD634170NB Bedienungsanleitung PDF herunterladen (Seite 15)

burner for the burner to operate

correctly.

6.3 Cleaning the hob

• Remove immediately: melted plastic,

plastic foil, and food with sugar. If not,

the dirt can cause damage to the hob.

Put the special scraper on the glass

surface at an acute angle and move

the blade on the surface.

• Remove when the hob is sufficiently

cool: limescale rings, water rings, fat

stains, shiny metallic discoloration.

Clean the hob with a moist cloth and

some detergent. After cleaning, rub

the hob dry with a soft cloth.

• To clean the enamelled parts, cap

and crown, wash them with warm

soapy water and dry them carefully

before you put them back.

6.4 Cleaning the spark plug

This feature is obtained through a

ceramic ignition candle with a metal

electrode. Keep these components well

clean to prevent difficult lighting and

check that the burner crown holes are

not obstructed.

6.5 Periodic maintenance

Speak to your local Authorised Service

Centre periodically to check the

conditions of the gas supply pipe and

the pressure adjuster, if fitted.

7. TROUBLESHOOTING

WARNING!

Refer to Safety chapters.

7.1 What to do if...

Problem Possible cause Remedy

You cannot activate or oper-

ate the hob.

The hob is not connected to

an electrical supply or it is

connected incorrectly.

Check if the hob is correctly

connected to the electrical

supply. Refer to the connec-

tion diagram.

The fuse is released. Make sure that the fuse is

the cause of the malfunction.

If the fuse releases again

and again, contact a quali-

fied electrician.

Activate the hob again and

set the heat setting in less

than 10 seconds.

You touched 2 or more sen-

sor fields at the same time.

Touch only one sensor field.

STOP+GO function oper-

ates.

Refer to "Daily use" chapter.

There is water or fat stains

on the control panel.

Clean the control panel.

ENGLISH 15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare