AEG 35772G-M Bedienungsanleitung

AUS ERFAHRUNG GUT35772 GGas hobInstruction BookletGB

10Guarantee ConditionsAEG offer the following guarantee to the first purchaser of this appliance.1. The guarantee is valid for 12 months commencing wh

11Instruction for the InstallerEngineers technical dataBURNER RAPID SEMI-RAPID AUXILIARY TRIPLE(large) (medium) (small) CROWNPOSITION MAX MIN MAX MIN

12Important safety requirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations(Current Edition) and th

13InstallationImportantThis hob must be installed by qualified personnel to the relevant British Standards.Any gas installation must be carried out by

14560150 min48055 min.FO 2038Cut Out SizeThe dimensions of the cut-out are given in the diagram.680510Building InBuilding over a cupboard or drawerIf

15FO 2564ON/OFF SWITCHFLEXOUTLETON/OFF SWITCHFLEXOUTLET1FO 25632Building over a kitchen unit with doorProper arrangements must be taken indesigning

16FFitting the Hob into the worktopCarry out the building in of the hob as follows: put the sealssupplied with the hob, onthe edges of the cut out:

17Electrical connectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

18Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a double poleswitch between the hob and the electricity

19Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Po

2 Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. Ifyou need assistance, contact our Customer C

20A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on W (Ohms) x 1 scale andadjust zero if necessary. Test leads fro

21Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

22CommissioningWhen the hob has been fully installed it will be necessary to checkthe minimum flame setting. To do this, follow the procedure below.-

23Conversion from Natural Gas to LPGIt is important to note that this model is designed for use with natural gas but can beconverted for use with buta

35678-7201 11/02AEG Hausgeräte GmbHPostfach 1036D-90327 Nürnberghttp://www.aeg.hausgeraete.deCopyright

3l Do not use this hob if it is in contact with water. Do not operate the hob with wet hands.l Ensure the control knobs are in the OFF position when

4F{ContentsGuide to Use the instructionsThe following symbols will be found in the text to guide you throughout the Instructions:Safety InstructionsSt

5Description of the Hob1. Hob Top2. Semi-rapid burner3. Auxiliary burner4. Rapid burner5. Ultra-rapid burner6. Control knobsInstallationFig. 1Any gas

6Burner minimum maximumdiameter diameterTriple-crown 160 mm. 260 mm.Large (rapid) 160 mm. 240 mm.Medium (semi-rapid) 120 mm. 220 mm.Small (auxiliary)

7Before any maintenance or cleaning can be carried out, you must DISCONNECT the hobfrom the electricity supply.The hob is best cleaned whilst it is st

8Something Not Working?If the hob is not working correctly, please carry out the following checks before contactingyour local AEG Service Force Centre

9Service and Spare PartsWhen you contact the Service Force Centre, they will need the following information:1. Your name, address and post code.2. You