AEG FSS52600Z Bedienungsanleitung

USER MANUALEN User ManualDishwasherFSS52600Z

German de-grees (°dH)French degrees(°fH)mmol/l Clarke de-greesWater softener lev-el<4 <7 <0.7 < 51 2)1) Factory setting.2) Do not use salt

– = Acoustic signal off.– = Acoustic signal on.2. Press to change the setting.3. Press on/off to confirm the setting.6.5 AirDryAirDry improves the

XtraDry is a permanent option for allprogrammes other than andneed not to be selected at every cycle.In the other programmes the setting ofXtraDry i

6. Turn the cap of the salt containerclockwise to close the salt container.CAUTION!Water and salt can come outof the salt container whenyou fill it. A

2030BA DC1. Press the release button (B) to openthe lid (C).2. Put the detergent, in powder ortablets, in the compartment (A).3. If the programme has

Cancelling the programmePress and hold RESET until the applianceis in programme selection mode.Make sure that there is detergent in thedetergent dispe

• Do not put in the appliance itemsmade of wood, horn, aluminium,pewter and copper.• Do not put in the appliance items thatcan absorb water (sponges,h

2. Remove the filter (C) out of filter (B). 3. Remove the flat filter (A).4. Wash the filters.5. Make sure that there are no residuesof food or soil i

• If you regularly use short durationprogrammes, these can leavedeposits of grease and limescaleinside the appliance. To prevent this,we recommend to

Problem and alarm code Possible cause and solutionThe appliance stops andstarts more times during op-eration.• It is normal. It provides optimal clean

CONTENTS1. SAFETY INFORMATION...22. SAFETY INSTRUCTIONS...

Problem Possible cause and solutionPoor drying results. • Tableware has been left for too long inside a closedappliance.• There is no rinse aid or the

Problem Possible cause and solutionLimescale deposits on the ta-bleware, on the tub and onthe inside of the door.• The level of salt is low, check the

product to your local recycling facility orcontact your municipal office.*www.aeg.com22

ENGLISH 23

www.aeg.com/shop156913112-A-182018

manufacturer is not responsible for any injuries ordamages that are the result of incorrect installation orusage. Always keep the instructions in a sa

• If the supply cord is damaged, it must be replaced bythe manufacturer, its Authorised Service Centre orsimilarly qualified persons in order to avoid

• Do not pull the mains cable todisconnect the appliance. Always pullthe mains plug.• This appliance complies with theE.E.C. Directives.• UK and Irela

3. PRODUCT DESCRIPTION437 9 8 105611 121Upper spray arm2Lower spray arm3Filters4Rating plate5Salt container6Air vent7Rinse aid dispenser8Det

4. CONTROL PANEL1 2 93 4 5 6 7 81On/off button2Display3Delay button4Programme button (up)5Programme button (down)6TimeSaver button7XtraDry button8RESE

Programme Degree of soilType of loadProgramme phases OptionsP4 3)• Fresh soil• Crockery andcutlery• Wash 60 °C or 65 °C• Rinses• XtraDryP5 • Normal or

6. SETTINGS6.1 Programme selectionmode and user modeWhen the appliance is in programmeselection mode it is possible to set aprogramme and to enter the