AEG FAVORIT 99015 I Bedienungsanleitung Seite 16

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 20
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 15
Display TimeBeam Problem
SERVICE CODE
The anti-flood device is
on.
WARNING!
Deactivate the appliance before
you do the checks.
Problem Possible solution
You cannot activate the appli-
ance.
Make sure that the mains plug is connected
to the mains socket.
Make sure that there is not a damaged fuse
in the fuse box.
The programme does not start. Make sure that the appliance door is closed.
Press OK START.
If the delay start is set, cancel the setting or
wait for the end of the countdown.
The appliance does not fill with
water.
Make sure that the water tap is open.
Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter in the inlet hose is
not clogged.
Make sure that the inlet hose has no kinks or
bends.
The appliance does not drain
the water.
Make sure that the sink spigot is not clog-
ged.
Make sure that the drain hose has no kinks
or bends.
The anti-flood device is on. Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other messages,
contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
The released quantity of rinse aid is
too much. Adjust the rinse aid selector
to a lower position.
The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
The quality of the detergent can be
the cause.
Dishes are wet
The programme is without a drying
phase or with a low temperature dry-
ing phase.
The rinse aid dispenser is empty.
The quality of the rinse aid can be the
cause.
16
www.aeg.com
Seitenansicht 15
1 2 ... 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare