AEG HKL85416IB Bedienungsanleitung PDF herunterladen (Seite 19)

CAUTION!

Do not drill or solder the

wire ends. This is strictly

forbidden!

CAUTION!

Do not connect the cable

without cable end sleeve.

Two-phase connection

1. Remove the cable end sleeve from

black and brown wires.

2. Remove an insulation of the brown

and black cable ends.

3. Apply a new wire end sleeve of 1.5

mm² on each cable end. (special tool

required).

Cable cross section

230V~ 400V 2~N

One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N

Green - yellow Green - yellow

N Blue and blue Blue and blue N

L Black and brown Black L1

Brown L2

8.4 Attaching the seal to the

rabbet

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an

angle of 45°. They should fit in the

corners of the rabbets accurately.

4. Attach the stripes to the rabbets. Do

not extend the stripes. Do not bond

ends of stripes one over another.

After you assemble the hob, seal the

remaining gap between glass ceramic

and the worktop with silicone. Make sure

the silicone does not get under the glass

ceramic.

ENGLISH 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Keine Kommentare

AEG HKL85416IB Bedienungsanleitung Seite 19